Skip to content
$69 inspection — credited back in full when you book the repair.
Top ChimneySweeps(816) 573-3499

Chimney sweeping, inspection & repair in Belton, MO

Cass County · About 30 minutes south.

$69 inspection — credited back in full when you book the repair

Belton started as an 1870s railroad town and grew substantially after the war as the metro pushed south. The result is a large stock of 1950s to 1970s houses with conventional exterior masonry chimneys, sitting around a much older centre.

What actually goes wrong here

Crown and cap failure on post-war stacks now sixty to seventy years old. These chimneys were built with thin flush crowns and frequently no cap at all, and both have now been taking weather for long enough that the top of the stack is where nearly every Belton job starts.

What we get called out for in Belton

  • Crown rebuild with a proper overhang
  • First cap fitted to a chimney built without one
  • Repointing the exposed courses above the roofline
  • Sweeping and inspection before the heating season

This kind of work, around the metro

Red brick chimney with the failed crown removed, exposing the clay flue tile and top course of brick mid-rebuild
Crown removed down to sound brick before the new cap is poured.
The same Kansas City chimney after repointing, with a newly poured concrete crown and two stainless steel caps installed
Same chimney: joints repointed, new crown poured with an overhang, two stainless caps fitted.

Every photo on this site is our own work. We do not use stock photography.

Housing in Belton, and why it matters

A chimney is a product of the decade the house went up in. Here is how Belton breaks down:

EraWhat was built, and what it means for the chimney
1871–1940Railroad-era town centre with older masonry
1950–1980The bulk of the housing: exterior masonry stacks, thin crowns
1995–presentNewer subdivisions with prefab chases

Local detail

Belton grew along the railroad from 1871 and then again as post-war Kansas City expanded south, leaving a large cohort of mid-century chimneys that have all reached the end of their original crowns at once.

Neighbourhoods we work in regularly: Downtown Belton · Cambridge · Eagle Ridge · Markey Road corridor

Services in Belton

Chimney Sweep

A chimney sweep removes the creosote, soot and debris that build up inside your flue during the burning season, restoring draft and removing the fuel source for a chimney fire.

Chimney Inspection

A chimney inspection is a documented condition assessment of the flue, liner, firebox, crown, cap and flashing, delivered as a written report with photographs rather than a verbal opinion.

Chimney Repair

Chimney repair covers the masonry itself — repointing failed mortar joints, replacing spalled brick, rebuilding a cracked crown, and in the worst cases taking the stack down to a sound course and rebuilding it.

Chimney Cap Installation

A chimney cap is a stainless or copper cover with a spark screen that sits over the flue opening, keeping rain, animals and debris out of the chimney while still letting exhaust and draft through.

Chimney Leak Repair

Chimney leak repair means locating the real water entry point — flashing, crown, cap, or porous masonry — and fixing that, rather than sealing the ceiling stain and hoping.

Gas Fireplace Repair

Gas fireplace repair covers the ignition and gas train — pilot assemblies, thermocouples and thermopiles, ignition modules, gas valves, blowers and door glass — on direct-vent, B-vent and vent-free units.

Gas Fireplace Inspection

A gas fireplace inspection verifies that the appliance is burning correctly and venting completely — gas pressure, burner flame pattern, vent integrity and a carbon monoxide spillage test — documented in writing.

Questions from Belton homeowners

What kind of chimney problems are most common in Belton?

Crown and cap failure on post-war stacks now sixty to seventy years old. These chimneys were built with thin flush crowns and frequently no cap at all, and both have now been taking weather for long enough that the top of the stack is where nearly every Belton job starts.

Do you actually come out to Belton, MO?

Yes. About 30 minutes south. We are open open 24 hours, 7 days a week, and the $69 inspection applies here exactly as it does anywhere else in the metro — credited back in full when you book the repair.

How much does a chimney inspection cost in Belton?

$69 for a full Level 1 inspection with a written report and photographs. Book any repair off that report and the $69 comes off the invoice. Level 2 video inspections, which NFPA 211 calls for on a property sale, are quoted per flue.

Book in Belton

$69 for the inspection, credited back in full when you book the repair. About 30 minutes south.

Prefer to type? Leave your details and we will come back to you. For anything urgent, calling is faster.

Give us a phone number or an email — either is fine, we just need one way to reach you.

Nearby

$69 inspection in Belton

Credited back in full when you book the repair.

(816) 573-3499