Chimney sweeping, inspection & repair in Mission Hills, KS
Johnson County · About 15 minutes south-west.
$69 inspection — credited back in full when you book the repair
Mission Hills is the oldest money in Johnson County and it shows in the chimneys. These are 1920s and 1930s J. C. Nichols estate houses with full masonry stacks, frequently three or four flues in one structure serving a fireplace, a boiler and a secondary hearth. Nothing here is factory-built, and almost nothing here is small.
What actually goes wrong here
Multi-flue stacks where one flue has been abandoned and left uncapped. Decommission a boiler flue and nobody caps it, so for decades rain enters a chimney nobody thinks about, saturating the shared masonry and pushing damage sideways into the flue still in use. The fireplace fails and the cause is a flue that has not been lit since the 1970s.
What we get called out for in Mission Hills
- Multi-flue caps fabricated to fit non-standard 1920s stacks
- Abandoned boiler flues found open and taking water
- Crown rebuilds on oversized estate chimneys
- Access work where slate and tile roofs make the stack hard to reach
- Repointing with mortar soft enough for early-century brick
This kind of work, around the metro
Every photo on this site is our own work. We do not use stock photography.
Housing in Mission Hills, and why it matters
A chimney is a product of the decade the house went up in. Here is how Mission Hills breaks down:
| Era | What was built, and what it means for the chimney |
|---|---|
| 1914–1940 | The great majority: Nichols-era estate houses, full masonry, multiple flues |
| 1946–1965 | Infill on remaining lots, still masonry but simpler |
| 1990–present | Teardown rebuilds, often with modern gas inserts in original openings |
Local detail
Mission Hills was laid out by J. C. Nichols in 1914 with curving streets built to the contour rather than a grid, which is also why its chimneys sit at awkward roof angles that standard caps do not fit.
Neighbourhoods we work in regularly: Indian Hills · Sunset Drive · Mission Drive · Verona Columns area
Services in Mission Hills
Chimney Sweep
A chimney sweep removes the creosote, soot and debris that build up inside your flue during the burning season, restoring draft and removing the fuel source for a chimney fire.
Chimney Inspection
A chimney inspection is a documented condition assessment of the flue, liner, firebox, crown, cap and flashing, delivered as a written report with photographs rather than a verbal opinion.
Chimney Repair
Chimney repair covers the masonry itself — repointing failed mortar joints, replacing spalled brick, rebuilding a cracked crown, and in the worst cases taking the stack down to a sound course and rebuilding it.
Chimney Cap Installation
A chimney cap is a stainless or copper cover with a spark screen that sits over the flue opening, keeping rain, animals and debris out of the chimney while still letting exhaust and draft through.
Chimney Leak Repair
Chimney leak repair means locating the real water entry point — flashing, crown, cap, or porous masonry — and fixing that, rather than sealing the ceiling stain and hoping.
Gas Fireplace Repair
Gas fireplace repair covers the ignition and gas train — pilot assemblies, thermocouples and thermopiles, ignition modules, gas valves, blowers and door glass — on direct-vent, B-vent and vent-free units.
Gas Fireplace Inspection
A gas fireplace inspection verifies that the appliance is burning correctly and venting completely — gas pressure, burner flame pattern, vent integrity and a carbon monoxide spillage test — documented in writing.
Questions from Mission Hills homeowners
What kind of chimney problems are most common in Mission Hills?
Multi-flue stacks where one flue has been abandoned and left uncapped. Decommission a boiler flue and nobody caps it, so for decades rain enters a chimney nobody thinks about, saturating the shared masonry and pushing damage sideways into the flue still in use. The fireplace fails and the cause is a flue that has not been lit since the 1970s.
Do you actually come out to Mission Hills, KS?
Yes. About 15 minutes south-west. We are open open 24 hours, 7 days a week, and the $69 inspection applies here exactly as it does anywhere else in the metro — credited back in full when you book the repair.
How much does a chimney inspection cost in Mission Hills?
$69 for a full Level 1 inspection with a written report and photographs. Book any repair off that report and the $69 comes off the invoice. Level 2 video inspections, which NFPA 211 calls for on a property sale, are quoted per flue.
Book in Mission Hills
$69 for the inspection, credited back in full when you book the repair. About 15 minutes south-west.