Chimney sweeping, inspection & repair in Gardner, KS
Johnson County · About 45 minutes south-west; we schedule these ahead.
$69 inspection — credited back in full when you book the repair
Gardner has the youngest housing stock of anywhere we serve. The city has grown more than fivefold since 1993, and nearly all of that construction is post-2000. That means very little traditional chimney work: what is here is overwhelmingly direct-vent gas fireplaces venting horizontally through an exterior wall, or sealed factory-built units in framed chases, with almost no masonry at all.
What actually goes wrong here
Termination clearance and blocked direct vents. On a house this new the masonry is not the problem — the venting is. Direct-vent terminations get buried by later landscaping, blocked by a deck the owner added, snow-drifted, or nested in. A blocked termination on a sealed unit means the appliance either locks out or, worse, spills. Nothing about it is visible from indoors.
What we get called out for in Gardner
- Direct-vent termination blocked, buried or nested
- Gas fireplace that locks out and will not restart
- Annual service on a unit that has never been touched
- Chase cover on the older 1990s edge of town
- Carbon monoxide check after an alarm
This kind of work, around the metro
Every photo on this site is our own work. We do not use stock photography.
Housing in Gardner, and why it matters
A chimney is a product of the decade the house went up in. Here is how Gardner breaks down:
| Era | What was built, and what it means for the chimney |
|---|---|
| 2000–2025 | The overwhelming majority: direct-vent gas, sealed units, often no chimney at all |
| 1993–2000 | The first wave of the boom: factory-built prefab in framed chases |
| pre-1990 | Small original town core, a modest amount of older masonry |
Local detail
Gardner has grown more than five times larger than it was in 1993. That single fact explains the service mix here: it is a gas-appliance town, not a masonry town, and it needs a different annual visit.
Neighbourhoods we work in regularly: Cedar Crest · Prairie Trace · Tuscan Farms · Downtown Gardner
Services in Gardner
Chimney Sweep
A chimney sweep removes the creosote, soot and debris that build up inside your flue during the burning season, restoring draft and removing the fuel source for a chimney fire.
Chimney Inspection
A chimney inspection is a documented condition assessment of the flue, liner, firebox, crown, cap and flashing, delivered as a written report with photographs rather than a verbal opinion.
Chimney Repair
Chimney repair covers the masonry itself — repointing failed mortar joints, replacing spalled brick, rebuilding a cracked crown, and in the worst cases taking the stack down to a sound course and rebuilding it.
Chimney Cap Installation
A chimney cap is a stainless or copper cover with a spark screen that sits over the flue opening, keeping rain, animals and debris out of the chimney while still letting exhaust and draft through.
Chimney Leak Repair
Chimney leak repair means locating the real water entry point — flashing, crown, cap, or porous masonry — and fixing that, rather than sealing the ceiling stain and hoping.
Gas Fireplace Repair
Gas fireplace repair covers the ignition and gas train — pilot assemblies, thermocouples and thermopiles, ignition modules, gas valves, blowers and door glass — on direct-vent, B-vent and vent-free units.
Gas Fireplace Inspection
A gas fireplace inspection verifies that the appliance is burning correctly and venting completely — gas pressure, burner flame pattern, vent integrity and a carbon monoxide spillage test — documented in writing.
Questions from Gardner homeowners
What kind of chimney problems are most common in Gardner?
Termination clearance and blocked direct vents. On a house this new the masonry is not the problem — the venting is. Direct-vent terminations get buried by later landscaping, blocked by a deck the owner added, snow-drifted, or nested in. A blocked termination on a sealed unit means the appliance either locks out or, worse, spills. Nothing about it is visible from indoors.
Do you actually come out to Gardner, KS?
Yes. About 45 minutes south-west; we schedule these ahead. We are open open 24 hours, 7 days a week, and the $69 inspection applies here exactly as it does anywhere else in the metro — credited back in full when you book the repair.
How much does a chimney inspection cost in Gardner?
$69 for a full Level 1 inspection with a written report and photographs. Book any repair off that report and the $69 comes off the invoice. Level 2 video inspections, which NFPA 211 calls for on a property sale, are quoted per flue.